Slab Edge Profile

[lucas]

I have a slab edge profile (see attachment). For the width (at the bottom) and the depth, I'd like to have the capability of changing the dim for different cases. Is this possible? If so, how do I go about doing this? I do not want to have several different slab edge profiles for different turndown depths, etc. I'd like to have the control to adjust for each case using one profile. Thanks for your help and suggestions.

[jsoto1685]

I don't see an attachment. But yes you can.

[Dimitri Harvalias]

You'll need to edit the profile family and add some parameters. Once the parameters are in the profile you can create new types, each with different measurement values. Each slab edge can then be assigned a different profile type.

[Silleke]

Tip: Always make a profile that will flex. Easy, isn't it?
Your content will be very useful for other project.