Angled vertical border mullions

[damon.sidel]

I'm trying to create a mullion that is a parallelogram. It is the vertical border mullion on my storefront system to meet a parallelogram column. As you can see from the attached images, it comes in in the wrong spot. I've attached the family, too if anybody is willing to look at it. Thoughts? Suggestions?

[cliff collins]

Try using "disallow join" at the ends of the storefronts which intersect the special mullion.

A trick I have used in the past is to create a "normal" wall, then place on Opening in it, then insert the storefront/CW inside the opening--which "frees it up" from being hosted. ( Not sure if you have a normal wall
and the storefront, or if it's 100% storefront?)

To get this to clean up, you may also need custom mullions at the same angle/profile at the ends of the storefronts?

I'll give it a shot when I get some time.

Edit: I tried it; used an angle setting in the Mullion Type. see attached. does this help?