Davied2
2005-01-25, 09:27 AM
Hi There
Until last week I was using revit 6.1but last week our IT people have installed Release 7 and it works fine.
However, If I have a plan region over part of a wall which happens to be next to a wall intersection I have to slightly move my crop region so that it does not touch the adjoining wall otherwise this whole of this adjoing wall also becomes affected by the properties of the plan region and does not display correctly.
It does not cause much of a problem because I just move my region box over by 1mm and its all fine but I did not notice this happening in Release 6.1.
Am I imagining this or has any one else noticed a slight difference in plan region behaviour.
Regards
David
Until last week I was using revit 6.1but last week our IT people have installed Release 7 and it works fine.
However, If I have a plan region over part of a wall which happens to be next to a wall intersection I have to slightly move my crop region so that it does not touch the adjoining wall otherwise this whole of this adjoing wall also becomes affected by the properties of the plan region and does not display correctly.
It does not cause much of a problem because I just move my region box over by 1mm and its all fine but I did not notice this happening in Release 6.1.
Am I imagining this or has any one else noticed a slight difference in plan region behaviour.
Regards
David