View Full Version : Steel Fabrication
daniel.tansey187405
2012-02-29, 03:05 PM
I'm new, so be gentle. I've for the beams/columns/connections modeled and need to start placing everything on sheets to send to the steel fabricator. I'm looking to separate each piece out. How do I do this?
Thanks
jorgeluisg
2012-05-04, 03:47 PM
Do you receive any response for this? A few weeks ago I was looking for the same but I cant find nothig.
themuleman
2012-06-09, 02:01 AM
I tried to post a link in this reply, but was unsuccessful. If you go to au.autodesk.com>online classes>search classes(narrow by software<autocad structural detailing>) there is a power point presentation you can download that has been very helpful in my learning of ASD2012. Hope this helps
lucis29
2012-06-14, 08:08 AM
If you just want to print with "Automatic drawings", there is an option at:
Automatic printouts -> Formats and scales
There you can choose to print Single Profiles under Part Type
Under Arange views -> Mode - choose Single position.
billbe466349
2012-06-14, 07:08 PM
Printing details:
How are detail prints made by "non-automatic" method?
billbe :beer: (drunk again)
lucis29
2012-06-15, 08:23 AM
Printing details:
How are detail prints made by "non-automatic" method?
better :)
**** - 10 characters
billbe466349
2012-06-15, 08:40 PM
lucis29, I believe you!
To rephase; Where is the procedure to use to make "non-automatic" drawings? Is it shown in the ASD manual? If it is not, will you write a outline procedure?
thanks
jorgeluisg
2012-06-18, 04:46 PM
Thanks Billy132816, I will.
lucis29
2012-06-19, 11:11 AM
lucis29, I believe you!
To rephase; Where is the procedure to use to make "non-automatic" drawings? Is it shown in the ASD manual? If it is not, will you write a outline procedure?
thanks
I've made a small video. If there is something unclear, please tell me.
http://www.screencast.com/t/hAH9hwtFN
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.