Trim, copy, etc problem

[erin.81612]

Hello, I am not sure if I am in the correct discussion group. but here it goes. We currently had a worm. During and after the worm our copy, trim, etc command has been acting funny. When we highlight more than one object, line, etc, the computer only allows us to highlight one object. Has anyone heard of this before? I hope so.

Thank you in advance for you efforts, erin

[BrenBren]

Check your PickAdd variable. It should be set to 1


Also, I am moving this to the AutoCAD General forum, as it is better suited in that forum



Hello, I am not sure if I am in the correct discussion group. but here it goes. We currently had a worm. During and after the worm our copy, trim, etc command has been acting funny. When we highlight more than one object, line, etc, the computer only allows us to highlight one object. Has anyone heard of this before? I hope so.

Thank you in advance for you efforts, erin

[mike.reynolds]

Erin,

Try this, Go to the tool pull down menu and select options. Select the "Selections" tab and make sure "Use Shift to add to selection" is un-checked. Hope this fixes you problem!