Site Modeling - Subregion tool

[Doug]

Hey!

I am woking on a Site Plan, I got the Data form the surveyor. I am preparing the existing site parking layout with the Subregion Tool. Everything loofs fin in 3D but in 2D Plan view part of the paving disapares under the slope of the Topo. How do I fix this?

[patricks]

Can you post a screen shot of what's happening? The subregion tool merely splits up the surface into regions so you can apply different materials. It doesn't split up the surface itself into separate pieces.

OT your avatar looks cool, got a bigger pic of that car? :)

[MikeJarosz]

part of the paving disapares under the slope of the Topo. How do I fix this?

Check your cutting plane in the view. Your site may be rising above the plane and is being cut off. Also set the view to shaded. If you see brown earth where your parking should be, you can be sure it's been cut off by the cutting plane.

[Doug]

Thanks!

It was the cut plane.
The car is the Jaguar Turbine Electric. It's GREEN almost... There are a ton of pic's if you google it. I read some where it will sell for about a million two a copy.

Thanks again!