Can't adjust hatch pattern on end of wall?

[patricks]

I have a wall that I painted a brick material on the end of it. Then I found I could not adjust the brick course lines in the pattern as I can on other areas of walls. I tried setting the exterior to wrap around the end of the wall, which also applied the hatch to the end of the wall. But again I could not adjust the pattern.

Anyone else ever run into this issue?

[cliff collins]

Yep. Confirmed in RAC 2013.

Can't move the pattern lines ( brick running bond model pattern ) on the end of a wall that the Brick Material was painted on.

Could not even invoke Move/Disjoin command.

[damon.sidel]

Not that this _solves_ the problem, but could you miter the wall join and therefore have the face of the wall extend to the corner of each wall? Or do you need to see the end thickness of the wall?

[samcooke327753]

yes, very annoying...