How to define a table from a type of label

[bpoleuca878805]

Hello,
please somebody advise me how to make a table from a type a label.
I have in a project a label with a text (ex: secondary road, left/right) and I want to make a table from these labels because the label it's made from the text and the station value of my road I desgn.
Help.

[Opie]

What type of label are you working with? Can you provide a drawing or image showing what you have and what you are trying to accomplish?

[bpoleuca878805]

I can't upload the dwg file, but I made a printscreen and I it's attached
86524
I use the Alignment Station Offset Label because I put these laels manual.
From these type of labels I want to make diferent tables.
The labels I send you to see is made in intersection of 2 roads. One is my design road and the second is auxiliar. The labels show me the side of the auxiliar road and the station position along the design road.

[Opie]

I am not sure you can place alignment labels within a table.

I believe you could set points at each location and then place them within a table and associate them to an alignment for station / offset information.

[mjfarrell]

correct station and offset points will be needed to provide the information to this table.
\
Or one could place pipe network 'structures' and get a table from them.