peter.axl
2012-09-17, 01:57 PM
Hello,
The conceptual massing tool is... strange. The biggest challenge is to keep the in place-mass as simple as possible.
I've made a form from witch two atriums are cut with voids. These voids are created from a blend between two planar curves. For some reason, the resulting surfaces have different mapping properties. Most surfaces have a "planar" mapping of materials while other "stretches" materials and objects applied to it, see the attached image where I've painted a hatch to illustrate the issue. Is there any way to control the mapping??
As far as I can see the divide surface tool can only move, rotate and scale the "gizmo" of the division.
The conceptual massing tool is... strange. The biggest challenge is to keep the in place-mass as simple as possible.
I've made a form from witch two atriums are cut with voids. These voids are created from a blend between two planar curves. For some reason, the resulting surfaces have different mapping properties. Most surfaces have a "planar" mapping of materials while other "stretches" materials and objects applied to it, see the attached image where I've painted a hatch to illustrate the issue. Is there any way to control the mapping??
As far as I can see the divide surface tool can only move, rotate and scale the "gizmo" of the division.