peter.axl
2012-09-17, 02:00 PM
Hello,
The conceptual massing tool is... strange. The biggest challenge is to keep the in place-mass as simple as possible.
I've made a form from witch two atriums are cut with voids. These voids are created from a blend between two planar curves. For some reason, the resulting surfaces have different mapping properties. Most surfaces have a "planar" mapping of materials while other "stretches" materials and objects applied to it, see the attached image where I've painted a hatch to illustrate the issue. Is there any way to control the mapping??
As far as I can see the divide surface tool can only move, rotate and scale the "gizmo" of the division.
87096/Peter
The conceptual massing tool is... strange. The biggest challenge is to keep the in place-mass as simple as possible.
I've made a form from witch two atriums are cut with voids. These voids are created from a blend between two planar curves. For some reason, the resulting surfaces have different mapping properties. Most surfaces have a "planar" mapping of materials while other "stretches" materials and objects applied to it, see the attached image where I've painted a hatch to illustrate the issue. Is there any way to control the mapping??
As far as I can see the divide surface tool can only move, rotate and scale the "gizmo" of the division.
87096/Peter