Visiblity Problem

[Doug]

I am working on a 3 level project. When I am on the lowest level and turn on the overlay of the level above it does not show up. Works for all of the rest of layer either way (level above or below)

Is there a fix for this or am I doing something wrong?

Thanks

Doug

[bclarch]

Do you have another level (such as top of foundation) defined between the lowest level and the middle level? If this is so, then using "level above" will reference this level instead of the middle level that you want.

[luigi]

Try using the exact level instead of the level above, and you will see if Revit is recognizing another level as bclarch wrote.

[Doug]

I have a top of foundation level between but I selected 1st floor level in the drop down list. Works fin on all of the other levels except the bottom level.

Doug

[ChristinaB]

Do you have a floor system in place on the 1st floor....If so try turning the floor layer off.