CHANGING SLOPE ANGLE OF SLOPED GLAZING

[anders.hedman]

I changed the slope angle of a sloped glazing roof. All the curtain grids and mullions were deleted. There is certainly a simple way of preventing this from happening, but how is it done?

[beegee]

I believe this problem occurs when you change the pitch of sloped glazing, because some curtain grids on a panel are no longer meeting exactly at a point, creating a small triangular panel within the main panel; the triangular panel cannot be accurately regenerated because it is too small.



I don’t think there is a work-around for this. It is necessary to delete the offending mullions using the error dialogue and then recreate them

[Scott D Davis]

to delete the offending mullions using the error dialogue and then recreate them
Which takes one click with the mullion tool set to 'all empty segements', so not really so bad.

[anders.hedman]

Thanks for the replies. The solution occurred to be not to have the detail level set at "fine" when changing the angle.With detail level at "medium " or "coarse" the problem did not show up.