chrisr
2012-12-06, 12:48 PM
trying to cut an opening in a foundation wall that has had the profile shape amended. Using the shaft opening, it cuts the object above and below, but not the wall. Using the vertical opnening it cuts through but the opening automatically cuts through the entire lenght of the wall and does not allow you to shorten the lenght of the opening. This is the same for cutting an opening through the face of the wall.
I have used this toll a number of times before and no proble. Why???
Is this because the wall profile has been changed. Is there another way. Help needed, never as simple as it should be.
I have used this toll a number of times before and no proble. Why???
Is this because the wall profile has been changed. Is there another way. Help needed, never as simple as it should be.