jimlapier
2012-12-26, 06:51 PM
Any help / direction is greatly appreciated. I've searched the forums but cannot seem to find the answer.
I am learning Revit right now (been using AutoCAD for 15 years) and I am trying trying to create a specific stair situation.
I need about six risers to a landing, then 2 sets of risers (12 in each) from the landing to two opposing floors.
I've seen this mentioned in multiple reviews and it is shown on the wikihow page, but never explained how to accomplish it.
http://files.wikihelp.autodesk.com/RVT/2013/ENU/GUID-4A4BC84F-F17F-4F16-B2B7-8884234806AA-low.png
I was able to rough out an approximation using a single run, creating a "landing level" and creating a second stair from the landing level to the second, but could not get them to connect in a visually pleasant way. Thanks again!
I am learning Revit right now (been using AutoCAD for 15 years) and I am trying trying to create a specific stair situation.
I need about six risers to a landing, then 2 sets of risers (12 in each) from the landing to two opposing floors.
I've seen this mentioned in multiple reviews and it is shown on the wikihow page, but never explained how to accomplish it.
http://files.wikihelp.autodesk.com/RVT/2013/ENU/GUID-4A4BC84F-F17F-4F16-B2B7-8884234806AA-low.png
I was able to rough out an approximation using a single run, creating a "landing level" and creating a second stair from the landing level to the second, but could not get them to connect in a visually pleasant way. Thanks again!