theoryshaw
2013-01-08, 07:18 PM
In the following 2013 file: https://dl.dropbox.com/u/7117445/temp/Assemblies%26Filters.rvt
...if you turn off the visibility of the 'Assembly_One' filter in the 3D view, both the 'wall' and the 'assembly' should turn off.
The value for the 'test' parameter is 'Assembly_One' for both the wall and assembly.
The assembly is assigned to the Walls 'Naming Category'.
Any clues to why this assembly is not turning off?
Kind Regards, Ryan
...if you turn off the visibility of the 'Assembly_One' filter in the 3D view, both the 'wall' and the 'assembly' should turn off.
The value for the 'test' parameter is 'Assembly_One' for both the wall and assembly.
The assembly is assigned to the Walls 'Naming Category'.
Any clues to why this assembly is not turning off?
Kind Regards, Ryan