Export Setup question

[Twolly]

When I export to CAD, for some reason the ceilings in the RCPs keep going to the wrong layer. In the export setup I have set the ceilings to go to A-CLNG_SUSP but they keep going to the A-DETL-IDEN layer. The fill pattern is used to make the grid, but there is no way to set up which layers fill patterns go to, or at least as far as I can see.

I have attached my ceiling export setup.

Thanks!

[Twolly]

Sorry, I just figured out the answer to my own question. I realized that the view range for my RCP was incorrect and the ceiling was not showing up between the Cut plane and Top of the Primary Range. It showed up because it was in the view depth, but wasn't exporting correctly because of this.