block into xref problem

[yyildiran2000368400]

hi, i have a elecrical symbol library Which name is "semlistxref.dwg". when i used to autocad 2008 version, i xrefed my library file to my drawings.
after that my hole blocks have came into drawings automaticly. i could use these blocks one by one on my drawings. when i have tried to change any block into xref files, all my blocks into my drawings would replaced automaticly.
but i passed new computer and load 64 bit autocad 2012. Now even i putted my xref files to my drawings, i can't insert my blocks from xref files.

if any body to tell me to solition or xref settings about this topic, i'll be very happy.

thank you for your help.

[lesleys]

What might be a better way for you is to use design Centre. Open the DC and find the drawing you were going to xref in select it & then you can bring in not only blocks but layers, fonts etc. You can just drag the block or any of the other options into your drawing.

[topherton]

You should make sure the block name isn't part of the drawing. If it is, rename the block and then reinsert the block / xref.

[yyildiran2000368400]

hi everybody. sorry my late replay. i resisted what i believe to do, but i understand it was difficult. design center is solved my problem and thanks lesleys for suggestion.

[gfreddog]

FYI

In Design Center if you right click on the Drawing File (the Xref you were using) you can "Create a Tool Palette" for all the blocks in that drawing as well. You can then control/change the properties for each block (layer, explode, etc)

This is my personal favorite tool.