vince.lam
2013-04-04, 08:32 AM
Hi All
When you are using user defined hatch command under ACAD2013, is there any way you could specify the reference axis point?
I think its probably not clear on what I want to express, say, if you are using rotate function, you could use the reference function after you select the base point, the reference will let you identify the new "axis" then the new angle or point.
Is there a similar function under user defined hatch command as well?
Or if it will appear in 2014?
I know I could specify the angle if I measure the angle separately. But I think its quite a long winded way if you have quite a few hatched area you want use the user defined hatches all with different angles.
Many thanks.
When you are using user defined hatch command under ACAD2013, is there any way you could specify the reference axis point?
I think its probably not clear on what I want to express, say, if you are using rotate function, you could use the reference function after you select the base point, the reference will let you identify the new "axis" then the new angle or point.
Is there a similar function under user defined hatch command as well?
Or if it will appear in 2014?
I know I could specify the angle if I measure the angle separately. But I think its quite a long winded way if you have quite a few hatched area you want use the user defined hatches all with different angles.
Many thanks.