publish to DWF/titleblocks

[robert.1.hall72202]

Publishing to a dwf cuts off my titleblocks..............any suggestions?

[bmitchell]

We had a similar problem to that. We changed all of our plots to plot from a view. This eliminated the problem.

[Mike.Perry]

Hi

Have a browse of the following thread -

publishing to dwf from autocad crops drawing (http://forums.augi.com/showthread.php?t=13413)

Have a good one, Mike

[robert.1.hall72202]

I tried the DwfWriter 2 file from AutoDesk however I end up with uncombined
dwf prints. How can I add the sheets together? Is there a DWF combiner?

[Mike.Perry]

I tried the DwfWriter 2 file from AutoDeskHi

Did that work ie No "cuts off my titleblocks"?

If yes, look at setting up a Page Setup that uses this DWF output device, then within the Publish command apply this Page Setup to your Layouts.

Have a good one, Mike

[robert.1.hall72202]

Now it works, thanks a bunch, it was staring me in the face all day, lol.