Vertical bracing symbolic line ???

[kathey1]

Right i want to show my vertical bracing a hidden line in plan view so i have edited a flat plate family by drawing a dashed symbolic line in its family.
when i place the plate with start and end attachment level reference at 0 the symbolic line shows up but when i elevate one of the ends of the vertical bracing the symbolic line disappears.

Is there a way to show my symbolic line when my one end of my vertical bracing is elevated higher than the other (as normal bracing is shown) ???

Thank you

[david_peterson]

I believe you can set this in the structural settings under brace symbols. The trick here is that the structural brace symbol only show up in course detail level. Anything else and it's going to show the plate based off cut plane/view range.
Hope this helps.