Problem with U-shaped Stairs

[albino394381]

Hello everybody http://www.revitcity.com/images/smiles/smile.gif
So I am trying to make these monolitig U-shaped stairs...
I am creating them by sketch, because the U-shaped winder component doesen't give much freedom.
My problem is that the angled risers keep disappearig.
What might be the problem here?

[Steve_Stafford]

Check the Type Properties, uncheck the option regarding smooth underside of winder. Revit can't generate the form if set to smooth. (I don't have Revit open so I don't remember the exact parameter name)

[mathew.taylor71396995]

Why are you not making the u turn step at the end of first stair line or make their one big step and connect from the both corners. IN my opinion you should change the design.

[albino394381]

Hey, Mathew
If I understand correct you are talking about the middle riser (which in the picture is vertical line). Problem is I have no place to put new risers because I need the space under the stair for storage room. I can't remove it :(.

[albino394381]

Hi Steve,
Yes, that fixed it :). However I was going for smooth underside.
I think that either I will have to change the design or go and model this in-place.