View Break glitch

[damon.sidel]

I've encountered something new: I'm creating door and window details (wall section > detail callout) and normally I do a callout for the whole door and use the View Break to crop out the middle, add some break lines, and drag them together. However, when I drag them together, the fills in the section cut disappear. See attached image. Any ideas?

92735

[scourdx]

I have the same issue, but it won't affect when you print to PDF. My guess it could be graphical issue.

[damon.sidel]

Hmm, just tested it and you are correct, that it doesn't affect it when I print. That's at least a little help...

[dhurtubise]

Display issue are usually related to video drivers

[damon.sidel]

Display issue are usually related to video drivers

OK, I'm using a GeForce GTX 660 Ti with driver version 314.22, installed 4/10/2013. There is an update (320.49, 7/1/2013) available. Is there a list of tested video cards and drivers that I could check before I make any changes?

[patricks]

Yes there is a list, but everything on it is usually a minimum of 2-3 years old. I can already tell you for a fact that a GTX 660 card (or any GTX 600-series) is not going to be on the list.

I run a GTX 650 Ti at home and it seems to be working fine with 2013 and 2014.

[damon.sidel]

Thanks, patricks. I still have the glitch but have been dealing with it since it prints OK. Too bad the list is so old. :(