HP LaserJet 1160 - No print

[bazziemoto]

I have a new HP LaserJet 1160 and I cannot get this new printer to print from AutoCAD 2000. AutoCAD returns an error message: "Printing has been disabled due to drive incompatability. Are you completely sure this is an Hewlett-Packard device?"

HP says to go to CONFIG --> PLOTTING TAB --> USE AS DEFAULT OUTPUT DEVICE
--> OK. When plotting, I get the above message. Then I get an HPPREVIEW, the a blank sheet of paper out of the printer.

I did not have any problem with the HP LaserJet 6L before it was destroyed in a flood.

Any suggestions or cures?

[Mike.Perry]

Hi

Have a browse of the following thread -

HP Laserjet 11300 Compatibility Problems (http://forums.augi.com/showthread.php?t=13429)

Please note the above does not directly answer your particular issue / problem I only offer it in the hope it will give you one or two ideas that you might try.

Have a good one, Mike