t.marinou415611
2013-09-02, 06:58 PM
Hi All
I'm using sweeps to add parapet wall caps. On the flat wall it works a treat but when I use the sweep to go up the sloped wall (see 3d view), the cap twists on the slope (see section jpeg). Is there any way to fix this or or should I live with the fact that I'll always have to draw 2 separate wall caps? Thanks
93374 93373
I'm using sweeps to add parapet wall caps. On the flat wall it works a treat but when I use the sweep to go up the sloped wall (see 3d view), the cap twists on the slope (see section jpeg). Is there any way to fix this or or should I live with the fact that I'll always have to draw 2 separate wall caps? Thanks
93374 93373