Ceiling Problem

[hdjohnson]

I was wondering if there was any way to define more than one slope for a ceiling? The bottom chords of the trusses that we're using have a slope of 3/12 with the ridge running down the middle of the room. I've tried using the ceiling tool, but it won't let me define more than one slope. Any ideas?

[Steve_Stafford]

Can you split the ceiling into two halves sloping each individually?

[sbrown]

Steves solution is the best. I have no idea why revit doesn't currently allow multiple slopes on roof soffits or ceilings, but right now the only way is sep pieces then join geometry as needed.

[hdjohnson]

Thanks for your replies. I was getting ready to try splitting it in half, but I was hoping there was some dialogue box or setting I was missing...

[PeterJ]

Or use a 12 mm thick roof made of plasterboard.

This would be an issue if you wanted to host light fittings on the ceiling for a rendering for example, but otherwise it should be quite acceptable.