Best way to clean up floor and angled wall?

[Nasko]

I've created an angle wall using an in-place mass. There is a gap left between the floor and walls, however. You can't edit the profile of a floor, so is there any good way to get the two elements to clean up properly?
93969

Thanks in advance

[Dimitri Harvalias]

Welcome to the forums.
You could edit the floor sketch and take the outside line out far enough that it overlaps the wall, then join geometry.
Depending on the configuration and consistency of the wall/floor relationship you could also add a slab edge that would essentially add a sweep to fill that void.

[Nasko]

Welcome to the forums.
You could edit the floor sketch and take the outside line out far enough that it overlaps the wall, then join geometry.
Depending on the configuration and consistency of the wall/floor relationship you could also add a slab edge that would essentially add a sweep to fill that void.


Thanks! Slab Edge worked perfectly!
93992