Wish List System
2013-11-15, 10:50 AM
Summary: I would like the option to break the link between mirrored geometry.
Description: When modelling I would like to break the link between the mirrored geomtery. If we had this we could use the mirror tool to create geometry which is similar to the opposite side, but slightly different. For example. If I had a shaft with two holes either side. I could mirror one and then change the hole size. Which at present is not possible as if you change the original the mirrored feature will also change. All we would need is a break link tickbox in the mirror dialogue box
Product and Feature: Inventor - Part Modeling
Submitted By: Craig Snell on 11/15/2013
Description: When modelling I would like to break the link between the mirrored geomtery. If we had this we could use the mirror tool to create geometry which is similar to the opposite side, but slightly different. For example. If I had a shaft with two holes either side. I could mirror one and then change the hole size. Which at present is not possible as if you change the original the mirrored feature will also change. All we would need is a break link tickbox in the mirror dialogue box
Product and Feature: Inventor - Part Modeling
Submitted By: Craig Snell on 11/15/2013