droak
2005-02-25, 01:40 PM
Dear Augi:
I would like to have my Decimal Points line up in my Limit Tolerances.
When I have a dimension at or about 1.0 and I apply a limit tolerance to it and one limit is smaller than 1.00 and I suppress the leading zero, the decimal points do not line up vertically.
Is there a way to set the dimstyle to correct this. Or, is there a variable that controls this.
To tell you the truth, I don't remember this being an issue over the past several years, but right now I'm creating a drawing that has many dimensions that this condition applies to.
FYI, I am drawing with AutoCAD 2004.
Please open the attached Power Point File to see an illustration of my condition.
Respectfully,
Dr. Darrell
I would like to have my Decimal Points line up in my Limit Tolerances.
When I have a dimension at or about 1.0 and I apply a limit tolerance to it and one limit is smaller than 1.00 and I suppress the leading zero, the decimal points do not line up vertically.
Is there a way to set the dimstyle to correct this. Or, is there a variable that controls this.
To tell you the truth, I don't remember this being an issue over the past several years, but right now I'm creating a drawing that has many dimensions that this condition applies to.
FYI, I am drawing with AutoCAD 2004.
Please open the attached Power Point File to see an illustration of my condition.
Respectfully,
Dr. Darrell