LINKED NAMES NOT DIPSLAYING IN MEP MODEL

[sjsl]

We have an issue with our plumbing model not displaying room names on every floor. We have a four story building and have the Arch model linked into the MEP model. The rub comes from the mep model only displaying the room names on the 1st and 2nd floors but not the basement and 3rd floors. Everything looks right, categories, phases, but nothing seems to work event though it says they are there we just cant see them.

[CADastrophe]

Are you using Spaces or are you trying to Tag the Rooms in the Linked model?

[harkeychad]

I have this same issue and I am trying to get the room names and numbers on our Fire Protection Sheets. The rest of the sheets are fine. I am using a Template for these and it is set up just like the others. I am at a total loss.

[david_peterson]

Verify the cut plane hits the top of room.
Also make sure you have the rooms turned on.
Verify the Phase Mapping is correct.
Make sure the workset for the Rooms from the linked model has been turned on.

Just some first checks.

[harkeychad]

Thanks. I will check them all again.