Merge contours of Grade Object & Corr Surface

[tim_newsome]

See image

A modest statement of direction on how to tie embankment contours of Grading Object to Corridor Surface would be helpful.94447

[cadtag]

try creating a detached surface from the grading, and paste that into the corridor surface

[tim_newsome]

I see, I like the idea. Never have detached a surface though.

Is that a simple surface command?

Found it in "help"

[dgordon.68443]

in the case of this picture the grading or even seperate baseline in the corridor that goes around the radius should be pulled back so that the daylighting is closer to the daylighting of the straight section.

DanG

[dpresley58437170]

One method I've used is to copy the outermost feature line of the grading object on top of itself. Then, remove the grading object and add the copied feature line to the surface. The results are the same as using the grading object itself, and you can manipulate the resultant feature line if need be.