Gluing split walls?

[JamesVan]

Does anyone know of a way to 'glue' or re-join two segments of wall that were inadvertently split? Suggestions were made to redraw the wall, but the elevation profile of the wall was edited quite a bit and we don't want to redraw all that work.

Suggestions are greatly appreciated.

[Scott D Davis]

Go to the plan view, highlight the wall, and grab the handle point of one of the walls at the split, and drag it away from the split, and then drop it back on the split line. Usually this will cause the wall to heal back into one segment.

[David]

What about walls which were split vertically?

[Scott D Davis]

Did you mean 'horizontally split"?

Join geometry tool (i think this heals splits?)

Or

Delete the lower half of the wall below the split, and then change the properties of the top half of the wall to extend back down either to a level, or by a base offset distance.

[JamesVan]

Go to the plan view, highlight the wall, and grab the handle point of one of the walls at the split, and drag it away from the split, and then drop it back on the split line. Usually this will cause the wall to heal back into one segment.

Thanks, Scott. That did the trick!