Solid fill pattern

[scottyermer]

Actually I just worked it out but am not sure how to delete this post, so please ignore.

Hi there,

Im trying to create an overall solid fill pattern for walls, roofs and floors, but I just can't get the slab to do it, as shown on the attached drawing, I go into Visibility Graphics and override the cut pattern to solid fill without ant success. Any advice appreciated.

Cheers

Scott

[jsteinhauer]

Actually I just worked it out but am not sure how to delete this post, so please ignore.

Scott,

Please post your solution, as others may have the same question in the future. Did you graphically override the floors with a fill pattern similar to the walls and roof?

Cheers,
Jeff S.

[david_peterson]

If I had to guess it was a VG override for the view for all walls to show cut pattern as solid fill.

[scottyermer]

Hi, The solution was as David said, to override graphics in view and and select solid fill.

Cheers

Scotty