gregb
2014-03-26, 04:34 PM
I'm trying to make a custom stair that has risers coming up to a landing from two directions (see attached images). It looks fine in plan but the model is actually truncated as if the front of the stair is chopped off. Any idea why this is happening?
*sigh* Why is it you find the answer immediately after asking the question? The stair type had the Underside of Winder parameter set to Smooth. As soon as I changed that to Stepped the stair modeled properly.
*sigh* Why is it you find the answer immediately after asking the question? The stair type had the Underside of Winder parameter set to Smooth. As soon as I changed that to Stepped the stair modeled properly.