how do you make a section line jogged

[loc_vinh1836]

Need help. I have a section line going through a house 3/4 way then it turns 45degree.does anybody no how to do that.

[mlgatzke]

Unfortunately, this cannot be done with a single section-cut. The best way I've been able to do this is to create it as two separate sections, each one at the individual angles, then reconnect them on the sheet.

[beegee]

Mikes right, but this link (revit.autodesk.com/pillar/custserv/web/service/support_4.0/faq_navigator/index.asp) shows you how to do it in some detail.

Note: direct link doesn't work. Go to > Design Bar>Basics> Section> How To Create An Offset Section.