SECTIONS AT A ROUND ABOUT

[rmk]

Attached is a roundabout with sections at A thru H. the first alignment ends at the center and a new one begins.
I need to place sample lines at these sections (radially) and create section views from the center outward.

Any ideas of how this can be accomplished? I know you can pick an existing pline for a sample line. but the section view doesn't seem to be right.

[BlackBox]

Any ideas of how this can be accomplished?


Consider creating a separate Profile View for each section A-A, etc.

[DI Dad]

I would suggest either connecting the two alignments with a radius or create a separate alignment around, be sure to leave a gap, and then reference the final surface in your sections.