cnewell
2014-09-12, 06:04 PM
I think I might just be missing something so here it goes. I copy my existing ground profile by changing it temporarily to static. I can then lower the copy using the raise/lower pvi's. I then set the original existing ground profile back to dynamic. The profile that was copied and lowered is stays at static. Everything is fine until I save the drawing, close it, then re-open it. The copied/lowered profile is no longer lowered but back on top of the existing ground profile. Nothing I have read on blogs or discussion groups has mentioned having this problem.
Am I missing something here? -Thank you
Chris
Civil 3D 2014 SP2
Am I missing something here? -Thank you
Chris
Civil 3D 2014 SP2