View Full Version : 2015 variable roof thickness
MikeJarosz
2015-04-30, 04:35 PM
I created a roof type with variable rigid insulation thickness. The thermal layer is 2" rigid insulation. The 4 outside corner points are left at 0 0 and the center point is at +0 2". The roof section starts to slope, then remains flat. It falls short of the +0 2" high point. It seems something is preventing it from reaching the high point. What's happening here?
http://forums.augi.com/attachment.php?attachmentid=99542&stc=1
mike.r
2015-05-04, 09:10 PM
I created a roof type with variable rigid insulation thickness. The thermal layer is 2" rigid insulation. The 4 outside corner points are left at 0 0 and the center point is at +0 2". The roof section starts to slope, then remains flat. It falls short of the +0 2" high point. It seems something is preventing it from reaching the high point. What's happening here?
http://forums.augi.com/attachment.php?attachmentid=99542&stc=1
Can you post a plan view of the roof showing where the section line is cutting ?
dhurtubise
2015-05-05, 06:53 AM
Did you make any component variable?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.