jagostinho
2015-05-06, 02:52 PM
Hello,
I was looking on how to create a vertical Form that would pickup from a waving line both horizontally and vertically.
I would rather to use a Reference Line so that I can change the Form shape easily in the future but whenever I select Pick Lines the RefLine ends up flat on the 2D workplane.
I was wondering if there was a way to create a form by selecting an intersecting line as a result of a main mass cut by 2 void forms.
Please see image attached. Target line highlighted in yellow.
I also send project file attached with mass.
Any feedback is mostly appreciated as I am a begginer in massing.
J.
I was looking on how to create a vertical Form that would pickup from a waving line both horizontally and vertically.
I would rather to use a Reference Line so that I can change the Form shape easily in the future but whenever I select Pick Lines the RefLine ends up flat on the 2D workplane.
I was wondering if there was a way to create a form by selecting an intersecting line as a result of a main mass cut by 2 void forms.
Please see image attached. Target line highlighted in yellow.
I also send project file attached with mass.
Any feedback is mostly appreciated as I am a begginer in massing.
J.