patricks
2015-06-18, 06:00 PM
I noticed that when I load the Single Flush door family into a project, then hover the mouse over a placed door, the tool tip for the family name and also the family name displayed in the lower left corner is <Workset> : Doors : Single-Flush : 36" x 84" : R2
What the heck is the R2? That's the only door family I know of that does it, and it's showing it for every type of that same door family. I don't see anything in the instance or type parameters, or anything in the family itself that would make it have that R2 suffix. I'm not even sure what can make a family show a suffix after that type name like that.
Any ideas?
What the heck is the R2? That's the only door family I know of that does it, and it's showing it for every type of that same door family. I don't see anything in the instance or type parameters, or anything in the family itself that would make it have that R2 suffix. I'm not even sure what can make a family show a suffix after that type name like that.
Any ideas?