archy
2015-06-26, 01:28 AM
To indicate levels, such as on a floor,I prefer to use a Datum triangle with a wide triangle, with point downward, on a fine line.
For this the point of the triangle should the point at which the level is measured.
The Datum triangle available in the system family has no horizontal line, and it is defined with the insertion point at the middle of the wide part of the triangle so cannot be used with the point of the triangle indicating the spot at which the level is measured.
It is also defined with heavy 5-weight lines that turn it into a blob at scales over 1:100
Is there any way to achieve the appearance I prefer, (as shown in the plan view attached by the drawn symbol on the left, compared with the system datum triangles as shown to the right and centre)?
For this the point of the triangle should the point at which the level is measured.
The Datum triangle available in the system family has no horizontal line, and it is defined with the insertion point at the middle of the wide part of the triangle so cannot be used with the point of the triangle indicating the spot at which the level is measured.
It is also defined with heavy 5-weight lines that turn it into a blob at scales over 1:100
Is there any way to achieve the appearance I prefer, (as shown in the plan view attached by the drawn symbol on the left, compared with the system datum triangles as shown to the right and centre)?