In-Place walls and coarse scale fill pattern

[andrasx2253212]

Hi there,

I am just started looking for the feature to set the coarse fill pattern for an In-Place Wall created by extrusion however I just realised that this function is not available.
Is there any chance to use it with in-place walls?

Thanks,
Andras

[david_peterson]

Are you talking about an inplace family that you've set to a wall category?

[jspartz]

If you're talking about an in-place family in the walls category, then the answer is no. They don't have the graphics section with course scale parameters.
Instead, you can just put a view filter on, name it Wall Fill, check Walls, and Filter by: Area is greater than 0 so it grabs all the walls including the ones modeled in-place. Then set your pattern overrides.