Selecting door hinge side at insertion

[ted.evans]

I thought there was a way to select the door hinge side upon insertion of the door. All i seem to be able to do is select where on the wall and the swing side when inserting the door. Was there not a way to flip the hinge when inserting? Now i have to insert the door and then flip the hinge, adds a step.

[bhargis]

I have found this is a little touchy. If you are set to Automatic Offset, you can adjust the door swing by being on one side of the ghost door, but if you are placing it in the middle of the wall... I'm not sure and I'd like to see the responses to this.

[Steve_Bennett]

The only way you can switch sides that the hinge is on during insertion is if you have turned on Position along wall set to Offset/Center. Otherwise, you need to flip it after insertion. This would be a good wish list item.