kROSEMAN
2015-11-11, 12:10 AM
Hello All,
Does anyone know if its possible to adjust the auto join detection distance? I'm getting a little tired of having to select disallow join on walls when their ends are more than a foot from each other to keep them from extending and creating a wall corner that doesn't exist. I looked at the help file for the structural settings analytical model settings tab, specifically the tolerances settings but I am hesitant to make any changes to the settings there because I'm not entirely sure that the auto join for the physical geometry is driven by the analytical model lines. If it is and this is the cause, what other side affects could I expect with the model?
Thanks,
Kyle
Does anyone know if its possible to adjust the auto join detection distance? I'm getting a little tired of having to select disallow join on walls when their ends are more than a foot from each other to keep them from extending and creating a wall corner that doesn't exist. I looked at the help file for the structural settings analytical model settings tab, specifically the tolerances settings but I am hesitant to make any changes to the settings there because I'm not entirely sure that the auto join for the physical geometry is driven by the analytical model lines. If it is and this is the cause, what other side affects could I expect with the model?
Thanks,
Kyle