jeffrey.galbraith713639
2015-12-22, 09:39 PM
I want to create a roof edge fascia as a sweep object, but the path of the fascia deviates from the path of the roof edge in some places. How do I accomplish this? See sketch below.
102669
I can't find a way to draw the portion of the sweep path that is not on the roof surface. Is there a way to create a 3D polyline unrelated to any other geometry and use that as the basis for a sweep? Can I use the intersections of reference planes to create lines that drive the sweep?
Jeff
Revit Architecture 2015
102669
I can't find a way to draw the portion of the sweep path that is not on the roof surface. Is there a way to create a 3D polyline unrelated to any other geometry and use that as the basis for a sweep? Can I use the intersections of reference planes to create lines that drive the sweep?
Jeff
Revit Architecture 2015