david_peterson
2016-02-24, 02:16 PM
I noticed that out of the box it appears that Revit sets lineweights down to 1"=1'-0" for imperial drawings.
And I know we can change these.
My question is about what people are doing.
I received a comment from a co-worker that her drawing was looking flat at larger scales (3"=1'-0")
So I went and looked at the lineweight table and noticed it stops at 1"=1'-0". So I'm assuming that anything larger than that would use those same settings.
Have people created table set ups for these larger scale detail veiws (ie 3"=1'-0" and 6"=1'-0")?
Just curious to see what other firms have done.
Thanks in advance.
And I know we can change these.
My question is about what people are doing.
I received a comment from a co-worker that her drawing was looking flat at larger scales (3"=1'-0")
So I went and looked at the lineweight table and noticed it stops at 1"=1'-0". So I'm assuming that anything larger than that would use those same settings.
Have people created table set ups for these larger scale detail veiws (ie 3"=1'-0" and 6"=1'-0")?
Just curious to see what other firms have done.
Thanks in advance.