NEWBIE QUESTION - PLOTTING

[SIMA_FAREKAS728498]

Hey Guys,
I'm new to Revit and this forum; I've inherited a project; and I was just wondering if there is a way to plot at half scale with corrected scales, without having to set up new floor plans etc and new sheet sets?
TIA

[USMCBody]

I've found it's normally best from Revit or AutoCAD to print full size to PDF. Then print the PDF's at 50% using your PDF software, (ex bluebeam). Most PDF software has this built in one way or another, but it may also be that you can control it using the print driver.

[Revitaoist]

Here is an old trick of the trade: plot your sheets on ANSI D (22 x 32). Then you can plot to 11x17 at 50% and all the scales will be perfectly half so you can still use your architectural scale.