ARGHHHH! View Range

[Eric Stewart]

I have some CMU walls that go up to 4'-0". I want to show the hatch/poche in these walls in my plan. I have been fiddleing with view range settings and cannot get it to work.

What do I need to do? It is a simple one story fit-up. It should not be this hard or maybe I should call it a "Monday" issue.

Thanks

[Eric Stewart]

OK, this worked. I set my "bottom" to "Current Level" and the "offset " to -2'-0"

[Phil Palmer]

Revit walls that are below a certain height (1800mm) ? I think will not show as cut in plan view if they are drawn as an unconnected height.
You found the workaround for it though !