htlmv
2016-06-24, 06:29 PM
I've got a 4-story stair tower. 1st-2nd flr stairs as an assembled stairs. 2nd-4th floor stairs are assembled also but not 'attached' (1/2 to 2/4). on my 2nd floor enlarged plan, my stairs going down, stops showing risers but the supports are still visible. I think the only way to get the risers to show is the linework tool.
103700
also, between 3rd and 4th floor stairs, the double zigzag does not show up.
103701
and there is no way to set the cut plane for the stairs independently from the rest of the model/view?
Thanks,
Howard
103700
also, between 3rd and 4th floor stairs, the double zigzag does not show up.
103701
and there is no way to set the cut plane for the stairs independently from the rest of the model/view?
Thanks,
Howard