Joining wall sweeps built into wall profile?

[Nasko]

Hey guys,

I have a question regarding wall sweeps within wall profiles, not sure if it's possible to do.

In our wall construction, we are wrapping the sheathing and stucco around the top of the wall. Eventually we'll blow this up and draw the condition with detail items, but I'd like to show it as realistically as possible in our building sections. Graphically, I'd like to have a heavy line on the outside of what's being cut, with thin lines for everything in between. The problem is that the wall sweeps (one for sheathing, and one for EIFS) built into the profile cannot join, as shown, and show a thick line between the two profiles. Is it possible to join them, without having to model them as individual sweeps?

Please see attached images.

Thanks!

[barthbradley]

Are you still looking for a solution?

[Nasko]

Yes! Currently I've just been living with the thicker lineweight between the two sweeps, and I may remove the sweeps altogether, and just show the condition in a detail. I think having the sweeps integrated into wall profiles is great, but there should be better control of lineweight.