Attaching a wall to a sloped floor

[ashleyrogow734083]

Hello, I did some googling and while I found a few threads that were relevant, no answers were able to solve my (seemingly simple?) issue.

I have a floor that is sloped (a ramp), and I have walls that I would like to use on the sides of the ramp. Because the ramp is on a slope, I can't just put a wall on top of it without extending the wall quite a bit down below the ramp, which then interferes with the architecture underneath the ramp. I'd like to attach the walls' bottoms to the sloped floor.

The problem is that when I click Attach top/base, Revit will only attempt to attach the top of the wall to the ramp. The radio buttons for Base is Attached/Top is Attached are grayed out within the properties dialog. I would love if someone could help me figure out how to attach the bottom, not the top, of the walls to the sloped floor.

Thank you very much for your time.

[Yna-Db]

Hello, If you have access to french-english automatic translation (in Google Chrome for instance), here is a discussion round this topic with some illustrations : problème alignement poteau sur rampe (http://www.revitforum.org/forum-fran%E7ais/30680-probl%E8me-alignement-poteau-sur-rampe.html)

[damon.sidel]

Hi ashleyrogow, welcome on your first post!

I'd like to help, but nothing comes to mind and I can't duplicate your issue. If you post a screenshot, perhaps something will come to mind!

[ashleyrogow734083]

Hello, If you have access to french-english automatic translation (in Google Chrome for instance), here is a discussion round this topic with some illustrations : problème alignement poteau sur rampe (http://www.revitforum.org/forum-fran%E7ais/30680-probl%E8me-alignement-poteau-sur-rampe.html)

This solved my issue, thank you so much!